
Shower installation in Coventry, including electric, mixer and walk-in showers. We do the plumbing and any wiring ourselves, then test the shower before we leave. Quotes are free.
An electric shower heats cold water as it runs, so it works even when the hot water is off. It needs its own circuit from the consumer unit. A mixer shower blends hot and cold from your existing system and usually gives a stronger flow if your pressure is good.
Homes with a tank in the loft often have low pressure, which can make a mixer shower weak. Combi boilers and unvented cylinders give mains pressure. We check your system before you choose, and can suggest a pump or an electric shower if pressure is low.
A walk-in shower uses a fixed glass panel and a low tray, or a fully tiled wet room floor. Enclosures with doors suit smaller rooms, and over-bath showers need a good screen to keep water in. We'll help you pick the right setup for the space.
We visit to check your water system, the wall where the shower will go and, for an electric shower, the consumer unit. Then we recommend a type that suits your pressure and give you a free quote for the full installation.
We run the pipework, fit the valve or electric unit, and install any new circuit needed. The tray or bath area is sealed and tiled or clad, then the screen goes on. Finally, we test the flow, temperature and wiring and check for leaks.
Tell us about the leak, fault or project. We aim to respond the same day, and there's no call-out charge.
We look at the job in person and give you a free, no-obligation quote before any work starts.
We finish the job, test everything we have fitted and certify the work before we hand it back to you.
If your hot water comes from a cylinder fed by a tank in the loft, a pumped mixer shower can boost the flow. An electric shower is another option, as it runs from the cold mains. We check your system first, then recommend what will work best for you.
Usually, yes. Electric showers draw a lot of power, so they need their own circuit from the consumer unit with the right size of cable. If you're replacing an old shower, we check the existing cable can handle the new one. All the electrical work is tested and certified.
Yes. We take out the old shower, check the pipework or wiring that fed it and fit the new one. If the new shower is a different type or size, the wall may need making good or new tiles around it, which we'll include in your quote.
Replacing an electric shower with a similar model is a short job. Fitting a new mixer shower, a new circuit or a full walk-in enclosure with tiling takes longer, as walls and trays need time to set. We'll give you a timescale when we quote.
We fit showers in Coventry and the villages around it. Choose your area to see more.
Tell us what kind of shower you'd like, and we'll check your water pressure and quote for free.